Browse Standards
IEEE Guide for Making Corona (Partial Discharge) Measurements on Electronics Transformers
A uniform procedure for making corona (partial discharge) measurements by electrical means on electronic transformers is presented. Methods of applying voltage stress, the use of a sine-wave voltage to simulated dc and ac combinations, the ...
IEEE Guide for Functional Evaluation of Insulation Systems for AC Electric Machines Rated 2300 V and Above
A procedure that may be used to evaluate and compare insulation systems used, or proposed for use, in large ac electric machines is described in this guide.
IEEE Recommended Practice for Insulation Testing of AC Electric Machinery with High Voltage Rating up to 30 kV at Very Low Frequency
Described in this recommended practice are very low frequency withstand and diagnostic tests that are performed on the stator windings of ac electric machines.
IEEE Guide for Insulation Maintenance for Rotating Electric Machinery (5 Hp to Less Than 10 000 Hp)
In this standard, information necessary to permit an effective evaluation of the insulation systems of medium and small rotating electric machines is presented. The guide is intended to apply in general to industrial air-cooled machines rat...
AIEE Proposed Standard for Presenting Data on Magnetic Core Materials
The scope of this standard is to set forth the basic data on magnetic amplifier core materials that should be presented by manufacturers of core materials so that the magnetic amplifier designer will have available the parameters of the mat...
IEEE Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations
Uniform procedures for the measurement of radio noise generated by corona from overhead power lines and substations are established in this standard. Measurement procedures in this standard are also valid for other power-line noise sources ...
IEEE Recommended Practice for Thermal Evaluation of Sealed Insulation Systems for AC Electric Machinery Employing Form-Wound Pre-insulated Stator Coils for Machines Rated 6900 V and Below
A test procedure for comparing two or more sealed insulation systems in accordance with their expected life at rated temperature is outlined. The procedure is limited to insulation systems for alternating-current (ac) electrical machines us...
IEEE Standard Definitions and Requirements for Thyristor AC Power Controllers
These recommendations apply to thyristor ac power controllers that are low voltage, power elctronic, industrial class equipment for the control or switching of ac power. Switching, multicycle control and phase control are included. Cyclocon...
AIEE Proposed Standard for Graphical Symbols for Semiconductor Devices
These standards are supplementary to, and should be used in conjunction with American Standard Y32.2, Graphical Symbols for Electrical Diagrams. The following are some points of general philosophy underlying their development:1. The symbol ...
AIEE Test Code for Transistors - Semiconductor Definitions and Letter Symbols
The paper discussed the test code for transistors, its semiconductor definitions and letter symbols.