Browse Standards
IEEE Standard Codes, Formats, Protocols, and Common Commands for Use With IEEE Std 488.1-1987, IEEE Standard Digital Interface for Programmable Instrumentation
A set of codes and formats to be used by devices connected via the IEEE 488.1 bus is specified. This standard also defines communication protocols that are necessary to effect application-independent and device-dependent message exchanges, ...
IEEE Standard For Higher Performance Protocol for the Standard Digital Interface for Programmable Instrumentation
This standard applies to interface systems used to interconnect both programmable and nonprogrammable electronic measuring apparatus with other apparatus and accessories necessary to assemble instrumentation systems. It applies to the inter...
IEEE Standard Digital Interface for Programmable Instrumentation
Superseded by 488.1-2003. Interface systems used to interconnect both programmable and nonprogrammable electronic measuring apparatus with other apparatus and accessories necessary to assemble instrumentation systems are considered. The sta...
IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations Through the Use of Isolation Transformers
Engineering design procedures for the electrical protection of communication facilities serving electric supply locations through the use of isolation transformers are presented in this standard. These isolation transformers are hard-wired ...
IEEE Draft Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations Through the Use of Neutralizing Transformers.
This standard presents engineering design procedures for the electrical protection of communication facilities serving electric supply locations through the use of neutralizing transformers.
IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations Through the Use of Hybrid Facilities - Amendment 1
Safe and reliable methods for the electrical protection of telecommunication facilities serving electric supply locations through the use of metallic wire-line components in part of the telecommunication circuit, and optical fiber systems i...
IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations through the Use of Optical Fiber Systems
Safe and reliable methods for the electrical protection of telecommunication facilities serving electric supply locations through the use of optical fiber systems for the entire facility are presented in this standard.
IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations Through the Use of On-Grid Isolation Equipment
Workable methods for protecting wire-line telecommunication circuits entering electric supply locations are presented. The electric supply location environment; protection apparatus; service types, reliability, service performance objective...
IEEE Standard for the Electrical Protection of Communications Facilities Serving Electric Supply Locations -- General Considerations - Redline
General considerations are presented for the electrical protection of telecommunications facilities serving electric supply locations. This standard contains material that is common to the IEEE 487(TM) family of standards (i.e., dot-series)...
IEEE Recommended Practice for Sizing Lead-Acid Batteries for Stationary Applications - Redline
Methods for defining the dc load and for sizing a lead-acid battery to supply that load for stationary battery applications in float service are described in this recommended practice. Some factors relating to cell selection are provided fo...