Browse Standards
IEEE Standard for Electrical Measuring Transducer for Converting AC Electrical Quantities into DC Electrical Quantities
This standard applies to measuring transducers used for converting AC electrical quantities such as current, voltage, power (active or reactive), power factor, phase angle or frequency to direct current or voltage. Within the effective rang...
IEEE Standard Definitions of Terms for Nonlinear, Active, and Nonreciprocal Waveguide Components
This standard presents definitions of terms for non-linear, active, and non-reciprocal waveguide components. It is a companion to two other published standards, Definitions of Fundamental Waveguide Terms, IEEE Std 146-1980 and Definitions o...
IEEE Standard Test Procedure for Measuring Longitudinal Balance of Telephone Equipment Operating in the Voice Band
The basic requirements for a test circuit that can be used to measure longitudinal balance are defined. Resistive elements are specified because they are generally considered easy to duplicate and balance. Standard test conditions and proce...
IEEE Recommended Practice for the Detection and Measurement of Partial Discharges (Corona) During Dielectric Tests
This document is based on IEC Publication 270-1968, Partial Discharge Measurements. adheres closely to the IEC recommendations with the following exceptions:(1) The terms partial discharge energy and partial discharge power are not used in ...
AIEE Proposed Recommended Guide for Specification of Signal Sources
The purpose of these specifications is to give a common basis for comparison among signal sources used for test purposes. It is recommended that all manufacturers supply the information outlined where applicable. It is recognized that furth...
IEEE Recommended Practice for Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for Stationary Applications - Redline
Maintenance, test schedules, and testing procedures that can be used to optimize the life and performance of permanently installed, vented lead-acid storage batteries used for standby service are provided. Guidance to determine when batteri...
IEEE Standard for Ferroresonant Voltage Regulators
Ferroresonant transformers used as regulators in electronic power supplies and in other equipment are covered. Guides to application and test procedures are included.
IEEE Recommended Practice for Emergency and Standby Power Systems for Industrial and Commercial Applications
This Recommended Practice addresses the uses, power sources, design, and maintenance of emergency and standby power systems. Chapter 3 is a general discussion of needs for and the configuration of emergency and standby systems. Chapter 9 li...
IEEE Standard Practices and Requirements for Thyristor Converters for Motor Drives Part 1- Converters for DC Motor Armature Supplies
This standard applies to all types of line-commutated semiconductor power converters employing monocrystalline semiconductor thyristors or diodes, as used in industrial motor-drive applications requiring adjustable direct voltage for dc mot...
IEEE Guide for Thermal Resistivity Measurements of Soils and Backfill Materials
The measurement of thermal resistivity of soil and backfill materials to include concrete, engineered backfills, grout, rock, sand, and any other material used to encase the cable system installed in the ground is covered in this guide. A t...