Browse Standards
IEEE Recommended Practice for Battery Management Systems in Stationary Energy Storage Applications
Information and recommendations on the design, configuration, and interoperability of battery management systems in stationary applications is included in this recommended practice. The battery management system is considered to be a functi...
IEEE Guide for DC Inclined Plane Tracking and Erosion Test for Outdoor Insulation Applications
This guide is intended for a suitable use of dc voltages with the inclined plane tracking and erosion test for the evaluation of the tracking and erosion resistance of high voltage outdoor insulating materials.
IEEE Trial-Use Recommended Practice for Pulse-Type Partial Discharge Measurements on Individual Stator Coils and Bars
Pulse-type partial discharge test methods for individual form-wound stator coils and bars that are equipped with PD suppression coatings and energized with a sinusoidal voltage source are described in this recommended practice. A uniform pr...
IEEE Guide for Early Detection, Mitigation, Preventative Measures, and Response to Smoke, Fire, and Explosions in Underground Electrical Structures
Abstract: Failures of underground cables and accessories can result in the release of toxic gases and large amounts of energy. These failures include smoking manholes, manhole fires, and manhole explosions. These failure events can damage u...
IEEE Standard Test Procedure for Determining Circuit Integrity Performance of Fire Resistive Cable Systems in Passenger Rail and Road Tunnels
Standardization of circuit integrity cable testing is beneficial to cable manufacturers, distributors, and users. Uniform procedures, consistent, repeatable results, and measurable test acceptance criteria are required to allow comparisons ...
IEEE Standard for the Design of Chargers Used in Stationary Battery Applications
Utility battery chargers for stationary battery installations are critical to maximize battery life while supporting the continuous loads on the dc system. This standard is applicable to battery chargers used for stationary applications. It...
IEEE Guide for Design, Operation, and Maintenance of Battery Energy Storage Systems, both Stationary and Mobile, and Applications Integrated with Electric Power Systems
Application of this standard includes: (1) Stationary battery energy storage system (BESS) and mobile BESS; (2) Carrier of BESS, including but not limited to lead acid battery, lithiumion battery, flow battery, and sodium-sulfur battery; (3...
IEEE Standard for High-Voltage Direct-Current (HVDC) Composite Post Insulators
Outdoor and indoor composite station post insulators used in high-voltage direct-current power transmission systems are covered in this standard. The composite station post insulators covered by this standard consist of a load-bearing insul...
IEEE Recommended Practice for Overvoltage and Insulation Coordination of Transmission Systems at 1000 kV AC and Above
This recommended practice specifies the procedure for selection of insulation levels of UHV AC transmission lines and substations. It also specifies reliability criterion under switching overvoltage and lightning overvoltage. It also sugges...
IEEE Guide for On-Site Acceptance Tests of Electrical Equipment and System Commissioning of 1000 kV AC and Above
On-site acceptance tests of ultra-high-voltage power equipment are subject to thisguide. Criteria and requirements for test items, conditions, methods, and results are established.The stated specifications and requirements, both technical a...