Browse Standards
IEEE Guide for Selecting and Testing Jackets for Power, Instrumentation, and Control Cables - Redline
Properties of commonly used jackets, as well as selection and testing of jackets, are covered in this guide. It is written for those responsible for optimizing cable designs. The purpose is to present a reasonably complete picture of the ro...
IEEE Standard Specification Format Guide and Test Procedure for Linear, Single-Axis, Digital, Torque-Balance Accelerometer
Superseded by IEEE 1293-1998. A guide for the preparation of a digital accelerometer specification and test procedure is provided. It is intended to provide common terminology and practice for manufacturers and users. The accelerometer cons...
IEEE Standard Supplement for Strapdown Applications to IEEE Standard Specification Format Guide and Test Procedure for Single-Degree-of-Freedom Rate-Integrating Gyros - Corrigendum 1: 3.3.9.2.2, 3.6.4.1.1, 3.6.4.1.2, 6.3, and 10.10.4.1
Corrections are made by this corrigendum to Strapdown Applications to IEEE Standard Specification Format Guide and Test Procedure for Single-Degree-of-Freedom Rate-Integrating Gyros, material already published in IEEE Std 529-1980.
IEEE Standard for Inertial Sensor Terminology - Redline
Terms and definitions relating to inertial sensors are presented in this standard. Usage as understood by the inertial sensor community is given preference over general technical usage of the terms herein. The criterion for inclusion of a t...
IEEE Approved Draft Guide for the Design and Installation of Cable Systems in Substations
The design, installation, and protection of wire and cable systems in substations are covered in this guide, with the objective of minimizing cable failures and their consequences.
IEEE Guide for the Installation of Overhead Transmission Line Conductors
General recommendations for the selection of methods, equipment, and tools that have been found to be practical for the stringing of overhead transmission line conductors and overhead groundwires are provided.
IEEE Guide for Testing Turn Insulation of Form-Wound Stator Coils for Alternating-Current Electric Machines
Made in this guide are suggestions on testing the dielectric strength of the insulation separating the various turns from each other within multi-turn form-wound coils to determine the acceptability of the coils. Typical ratings of machines...
IEEE Standard Letter Designations for Radar-Frequency Bands
Letter terms in common usage are related to the frequency ranges that they represent in this standard.
IEEE Draft Guide for Applying Harmonic Limits on Power Systems
IEEE Standard 519, IEEE Recommended Practices and Requirements for Harmonic Control in Electrical Power Systems [B1], provides procedures for controlling harmonics on the power system along with recommended limits for user harmonic injectio...
IEEE Standard for Harmonic Control in Electric Power Systems - Redline
Goals for the design of electrical systems that include both linear and nonlinear loads are established in this standard. The voltage and current waveforms that may exist throughout the system are described, and waveform distortion goals fo...