Browse Standards
IEEE Guide for Acceptance and Maintenance of Insulating Oil in Equipment
Recommendations are made regarding oil tests and evaluation procedures; methods of reconditioning and reclaiming conventional petroleum (mineral) dielectric oils; the levels at which these methods become necessary; and the routines for rest...
AIEE Specifications of 30 percent Rubber Insulation for Wire and Cable for General Purposes
These specifications apply to the insulation of electric wire and cable of the grade known as 30 per cent Hevea rubber.
IEEE Draft Standard Test Methods for Avalanche Junction Semiconductor Surge-Protective Device Components
This standard applies to the avalanche breakdown diodes used for surge protection on systems with voltages equal to or less than 1000 V rms or 1200 V dc. The avalanche breakdown diode surge suppressor is a semiconductor diode which can oper...
IEEE Draft Standard Test Methods for Low-Voltage Gas-Tube Surge- Protective Device Components IEEE Power Engineering Society Sponsored by the Surge Protective Devices Committee
IEEE Draft Guide for Diagnostic Field Testing of Electric Power Apparatus - Electrical Machinery
This is a guide for determining applicable tests and inspection techniques for various types of large rotating electric machines. It provides short discussions relating to the capabilities and limitations of each test, typical test procedur...
IEEE Guide for Diagnostic Field Testing of Fluid-Filled Power Transformers, Regulators, and Reactors
Diagnostic tests and measurements that are performed in the field on fluid-filled power transformers and regulators are described. Whenever possible, shunt reactors are treated in a similar manner to transformers. Tests are presented system...
IRE Standards on Navigation Aids: Definitions of Inertial Navigation Terms, 1962
Definitions of Inertial Navigation Terms
AIEE Standard for Semiconductor Rectifier Components
Definitions given herein apply specifically to semiconductor components used for rectification or control of electric power, or both. For the purpose of this standard, a semiconductor rectifier component is a semiconductor rectifier cell, r...
IRE Standards on Navigation Aids: Direction Finder Measurements, 1959
Describes the standardisation of measurement methods and procedures to enable the determination of a direction finder's (DF) characteristics which will permit analysis of DF performance in a uniform manner. Standard test conditions are give...
IEEE Standard Induction Motor Letter Symbols