Browse Standards
IEEE Graphic Symbols for Logic Diagrams (Two State Devices)
This standard establishes the graphic symbols for use in the preparation of logic diagrams representing logic functions implemented with two-state devices. The primary purpose of this standard is to enable a user to readily read and underst...
AIEE Standards for Perforated Tape
The purpose of this Standard is to formalize existing standards for 5-level perforated tape used in communications; to include standards for 6-level, 7-level, and 8-level tape which will be compatible with these 5-level standards, in order ...
AIEE Proposed Recommended Practice for Medium-Voltage Motor Controllers for Rubber and Plastics Industries
The provisions of this Recommended Practice apply to the construction and application of controllers for alternating-current motors in the medium-voltage classification (601 to 5,000 volts). Although many of the specifications herein have b...
IEEE Recommended Practice: Definitions of Basic Per-Unit Quantities for AC Rotating Machines
The proper selection of base values is fundamental to the usefulness of a per-unit system. Although per-unit quantities have been used for many years by designers of rotating machinery, the base quantities were not standardized, and it was ...
IEEE Test Procedure for Airborne Sound Measurements on Rotating Electric Machinery
This test procedure defines approved methods for conducting tests and reporting results to effect the uniform determination of rotating electric machine sound under steady-state conditions with an accuracy of +or-3 dB tested in three acoust...
IEEE Test Procedure for Determining Tensile Strength and Hardness of Lead Sheaths
This standard recommends testing procedure for tensile strength, elongation, and hardness tests on samples of lead sheaths removed from cables.
IEEE Test Procedure for Radial Power Factor Tests on Insulating Tapes in Paper-Insulated Power Cable
A test procedure for determining the radial power factor of insulating tapes in power cable is presented. Three-terminal type electrodes are mounted in a test cell and pressure is applied to the insulating tapes.<<ETX xmlns:mml="http://www....
IEEE Recommended Practice for Impulse Voltage Tests on Insulated Cables and Their Accessories - Redline
A recommended practice for impulse testing of insulated cables and their accessories is described. The intention is to supplement insulated cable and their accessory standards by providing specific procedures for impulse testing on specific...
IEEE Guide for Measurement of Impedance and Safety Characteristics of Large, Extended or Interconnected Grounding Systems
Practical instrumentation methods are presented for measuring the ac characteristics of large, extended or interconnected grounding systems. Measurements of impedance to remote earth, step and touch potentials, and current distributions are...
IEEE Draft Guide for Measuring Earth Resistivity, Ground Impedance, and Earth Surface Potentials of a Grounding System
Practical test methods and techniques are presented for measuring the electrical characteristics of grounding systems. Topics addressed include safety considerations, measuring earth resistivity, measuring the power system frequency resista...