Browse Standards
IEEE Approved Draft Standard for Qualifying Alternating Current Class 1E Motors for Nuclear Power Generating Stations
It is required that Class 1E motors, with their interfaces, meet or exceed the specified performance requirements throughout their service life. This is accomplished through a program that includes, but is not limited to, design, qualificat...
IEEE Standard for Electrical Installation of Packaging Machinery and Associated Equipment
This standard covers the application of electrical equipment and wiring furnished as part of a packaging machine and associated equipment commencing at the place of connection of the power supply. It shall apply to electrical equipment for ...
IEEE Application Guide for Transient Recovery Voltage for AC High-Voltage Circuit Breakers rated on a symetical current basis.
This standard covers the application guide for transient recovery voltage requirements for ac high-voltage circuit breakers rated above 1000 volts and on a symmetrical current basis. The capability limits of these circuit breaker interrupti...
IEEE Standard Test Procedures for Germanium Gamma-Ray Detectors
Terminology and standard test procedures for germanium radiation detectors that are used for the detection and high-resolution spectrometry of gamma rays, X rays, and charged particles that produce hole-electron pairs in the crystal lattice...
IEC/IEEE International Standard - Nuclear facilities -- Electrical equipment important to safety -- Qualification - Redline
IEEE Recommended Practice: Rules for the Use of Units of the International System of Units
IEEE Application Guide for High Voltage Circuit Breakers Rated on a symmetrical current Basis
This application guide applies to AC high-voltage circuit breakers rated in accordance with the methods given in American National Standard Rating Structure for AC High-Voltage Circuit Breakers, C37.04-1964 (R 1969) and listed in American N...
IEEE Standard on Magnetostrictive Materials: Piezomagnetic Nomenclature
This standard serves to aid the comparison of the relative merits of magnetostrictive, electromagnetic, piezoelectric, and electrostrictive transducers. The standard applies generally to magnetostrictive materials and was developed for thos...
IEEE Trial Use Standard Guide on Solid State Devices: Varactor Measurements Part 1- Small Signal Measurements
This guide describes several methods of measurement for the small signal characterization of varactors. For the purpose of this guide, a varactor is defined as a twoterminal device used as a voltage-dependent capacitance. Such devices can b...
IEEE Draft Standard for Electric Penetration Assemblies in Containment Structures for Nuclear Power Generating Stations
An electric penetration assembly is an assembly of insulated electric conductors, conductor seals, module seals (if any), and aperture seals that provides the passage of the electric conductors through a single aperture in the nuclear conta...