Browse Standards
IEEE Recommended Definitions of Terms for Automatic Generation Control on Electric Power Systems
The need for standard terminology in the field of automatic generation control (AGC) became apparent when it was noted that authors of technical papers covering this technology frequently used different terms to convey identical meanings. T...
AIEE Proposed Guide for Transformer Impulse Tests
The Standards of AIEE, NEMA, and ASA plus the purchaser's specifications determine the specific requirements for impulse tests. This Guide will not change the Standards in any way, but adds background information which will aid in the inter...
AIEE Recommended Practice for A-C System Voltage Nomenclature for Industrial and Commercial Power Systems
Nomenclature for alternating-current system voltage should include designations for nominal system voltages and, associated with each nominal voltage: (1) an identification of the minimum and maximum acceptable limits for the system operati...
IEEE Graphic Symbols for Logic Diagrams (Two State Devices)
This standard establishes the graphic symbols for use in the preparation of logic diagrams representing logic functions implemented with two-state devices. The primary purpose of this standard is to enable a user to readily read and underst...
AIEE Standards for Perforated Tape
The purpose of this Standard is to formalize existing standards for 5-level perforated tape used in communications; to include standards for 6-level, 7-level, and 8-level tape which will be compatible with these 5-level standards, in order ...
AIEE Proposed Recommended Practice for Medium-Voltage Motor Controllers for Rubber and Plastics Industries
The provisions of this Recommended Practice apply to the construction and application of controllers for alternating-current motors in the medium-voltage classification (601 to 5,000 volts). Although many of the specifications herein have b...
IEEE Recommended Practice: Definitions of Basic Per-Unit Quantities for AC Rotating Machines
The proper selection of base values is fundamental to the usefulness of a per-unit system. Although per-unit quantities have been used for many years by designers of rotating machinery, the base quantities were not standardized, and it was ...
IEEE Test Procedure for Airborne Sound Measurements on Rotating Electric Machinery
This test procedure defines approved methods for conducting tests and reporting results to effect the uniform determination of rotating electric machine sound under steady-state conditions with an accuracy of +or-3 dB tested in three acoust...
IEEE Test Procedure for Determining Tensile Strength and Hardness of Lead Sheaths
This standard recommends testing procedure for tensile strength, elongation, and hardness tests on samples of lead sheaths removed from cables.
IEEE Test Procedure for Radial Power Factor Tests on Insulating Tapes in Paper-Insulated Power Cable
A test procedure for determining the radial power factor of insulating tapes in power cable is presented. Three-terminal type electrodes are mounted in a test cell and pressure is applied to the insulating tapes.<<ETX xmlns:mml="http://www....