Browse Standards
IEEE Recommended Practice for the Design of Buswork Located in Seismically Active Areas - Redline
Recommended practices for the engineering and design of flexible and rigid bus connections for bus and equipment in electric power substations located in seismically active areas are provided in this document.
IEEE Guide for the Application, Maintenance, and Evaluation of Room-Temperature Vulcanizing (RTV) Silicone Rubber Coatings for Outdoor Ceramic Insulators
The various important aspects that need to be considered for satisfactory long-term performance of room-temperature vulcanizing (RTV) silicone rubber high-voltage insulator coatings (HVIC) are outlined in the guide. Methods of application, ...
IEEE Standard for Testability and Diagnosability Characteristics and Metrics
This standard was developed to provide standard, unambiguous definitions of testability diagnosability metrics and characteristics. It builds on fundamental definitions derived from elements in formal information models related to test and ...
IEEE Recommended Practice for Electronic Power Subsystems: Parameter Definitions, Test Conditions, and Test Methods
This recommended practice defines many common parameters for ac-dc and dc-dc electronic power distribution components and subsystems. This enables electronic system engineers, manufacturers, and researchers to speak with a common language a...
IEEE Guide for Investigating and Analyzing Shielded Power Cable Failures on Systems Rated 5 kV Through 46 kV
This guide covers specific methods of failure mode classifications and analysis for shielded power cables rated 5 kV through 46 kV.
IEEE Guide for Investigating and Analyzing Power Cable, Joint, and Termination Failures on Systems Rated 5 kV Through 46 kV
This guide applies to the process of investigating, evaluating, and analyzing field failures. This guide covers the overall format for failure analysis and subsequent guides will specifically address cables, joints, terminations and separab...
IEEE Standard for the Universal Test Interface Framework and Pin Configuration for Portable/Benchtop Test Requirements Utilizing IEEE 1505(TM) Receiver Fixture Interface Standard
Portable/benchtop test equipment applications are supported in this document by defining a mass interconnection scheme and pin configuration based upon IEEE Std 1505(TM)-2010 and IEEE Std 1505.1(TM)-2015. Particular emphasis has been placed...
IEEE Standard for the Common Test Interface Pin Map Configuration for High-Density, Single-Tier Electronics Test Requirements Utilizing IEEE Std 1505 - Redline
An extension to the IEEE 1505TM receiver fixture interface (RFI) standard specification is provided in this standard. Particular emphasis is placed on defining within the IEEE 1505 RFI standard a more specific set of performance requirement...
IEEE Standard Testability Method for Embedded Core-based Integrated Circuits - Redline
A mechanism for the test of core designs within a system on chip (SoC) is defined. This mechanism is a hardware architecture and the core test language (CTL) is leveraged to facilitate communication between core designers and core integrato...
IEEE Standard Interface for Hardware Description Models of Electronic Components
The standard interface for hardware description models of electronic components is defined. The primary audiences of this standard are model developers and implementers of software supporting this interface.