Browse Standards
IEEE Approved Draft Standard for Qualifying Alternating Current Class 1E Motors for Nuclear Power Generating Stations
It is required that Class 1E motors, with their interfaces, meet or exceed the specified performance requirements throughout their service life. This is accomplished through a program that includes, but is not limited to, design, qualificat...
IEEE Draft Standard for Electric Penetration Assemblies in Containment Structures for Nuclear Power Generating Stations
An electric penetration assembly is an assembly of insulated electric conductors, conductor seals, module seals (if any), and aperture seals that provides the passage of the electric conductors through a single aperture in the nuclear conta...
IEEE Draft Standard Requirements for Direct Current Instrument Shunts
The dc instrument shunts within this standard apply to shunts for use in direct current circuits to extend the current measuring range of devices (e.g. instruments, meters, protective relays, or low-voltage trip systems). The design and tes...
IEEE Recommended Practice for Auxiliary Devices for Rotating Electrical Machines in Class I, Division 2 and Zone 2 Locations and Class II, Division 2 and Zone 22 Locations - Redline
This recommended practice applies to the application and installation procedures of auxiliary devices in or on electric rotating machines that are employed in hazardous locations classified as Class I, Division 2 and Zone 2 and Class II, Di...
IEEE Standard Methods for Measuring Electromagnetic Field Strength for Frequencies Below 1000 MHz in Radio Wave Propagation
Standard methods for the measurement of electromagnetic field strength in radiowave propagation are described in detail. These are for frequencies below 1000 MHz, and include the standard-antenna method and the standard-field method.
IEEE Standard Method for Measuring the Shielding Effectiveness of Enclosures and Boxes Having all Dimensions between 0.1 m and 2 m
This standard provides uniform measurement procedures for determining the shielding effectiveness of electromagnetic (EM) shielding for a variety of enclosures and boxes having all dimensions between 0.1 m and 2 m in the radio frequency ran...
IEEE Standard Method for Measuring the Effectiveness of Electromagnetic Shielding Enclosures
Uniform measurement procedures and techniques are provided for determining the effectiveness of electromagnetic shielding enclosures at frequencies from 9 kHz to 18 GHz (extendable to 50 Hz and 100 GHz, respectively) for enclosures having a...
IEEE Standard Definitions of Terms, Letter Symbols, and Color Code for Hall Effect Devices
Definitions of 48 terms are accompanied by a list of 38 letter symbols and the standard crossed-rectangle-in-circle-with-crosswires circuit symbol, with the colour code for lead wires to p-type and n-type Hall generators.<<ETX xmlns:mml="ht...
IEEE Standard Methods for Measuring Electromagnetic Field Strength of Sinusoidal Continuous Waves, 30 Hz to 30 GHz
Two standard methods for field-strength measurement are described. The standard-antenna method consists of measuring the received power or open-circuit voltage developed in a standard receiving antenna by the field to be measured and comput...
IEEE Recommended Practice for Precision Coaxial Connectors at RF, Microwave, and Millimeteter-wave Frequencies-Part 3: Connector Effects, Uncertainty Specifications, and Recommendations for Performance
The P287 series of documents presents the combined efforts of IEEE P287 Working Group that reflect the knowledge and experience of leading specialists in the development and measurement of precision coaxial connectors for RF, microwave, and...