Browse Standards
IEEE Standard for Radix-Independent Floating-Point Arithmetic
A family of commercially feasible ways for new systems to perform floating-point arithmetic is defined. This standard specifies constraints on parameters defining values of basic and extended floating-point numbers; add, subtract, multiply,...
IEEE Standard Procedure for the Determination of the Ampacity Derating Factor for Fire-Protected Cable Systems - Redline
A detailed test procedure is provided for determining the ampacity derating factor in the following cable installation configurations: block-out or sleeve-type cable penetration fire stops; conduits covered with a protective material; tray ...
IEEE/CSA Standard for Impedance Heating of Pipelines and Equipment - Application Guide for Design, Installation, Testing, Commissioning, and Maintenance
An application guide for the design, installation, testing, commissioning, and maintenance of impedance heating systems for pipelines and equipment intended for use in general industrial applications is provided in this standard. This stand...
IEEE/CSA Standard for Impedance Heating of Pipelines and Equipment - General, Testing, Marking, and Documentation Requirements
The general requirements, testing, markings, and documentation for impedance heating systems for pipes and equipment intended for use in general industrial applications are provided in this standard. This standard provides requirements when...
IEEE/CSA Standard for Skin Effect Trace Heating of Pipelines, Vessels, Equipment, and Structures--Application Guide for Design, Installation, Testing, Commissioning, and Maintenance
An application guide for the design, installation, testing, commissioning and maintenance of skin effect trace heating systems for pipelines, vessels, equipment, and structures intended for use in general industrial applications are provide...
IEEE/CSA Standard for Skin Effect Trace Heating of Pipelines, Vessels, Equipment, and Structures - General, Testing, Marking, and Documentation Requirements
General requirements, testing, markings, and documentation for skin effect trace heating systems for pipelines, vessels, equipment, and structures intended for use in general industrial applications are provided in this standard. This stand...
IEEE Standard for Petroleum and Chemical Industry--Premium-Efficiency, Severe-Duty, Totally Enclosed Squirrel Cage Induction Motors from 0.75 kW to 370 kW (1 hp to 500 hp)
This standard applies to premium-efficiency totally enclosed fan-cooled (TEFC) and totally enclosed nonventilated (TENV), horizontal and vertical, single-speed, squirrel cage polyphase induction motors, 0.75 kW to 370 kW (1 hp to 500 hp), a...
IEEE Guide: Procedures for Testing Single-Phase and Polyphase Induction Motors for Use in Hermetic Compressors
This guide specifies test procedures to determine the efficiency and other performance characteristics of hermetic motors. Hermetic motors are electric motors designed to operate as integral parts of compressor units in refrigerators, air c...
IEEE Recommended Practice for Precision Centrifuge Testing of Linear Accelerometers - Redline
This recommended practice describes the conduct and analysis of precision tests that are to be performed on linear accelerometers using centrifuge techniques. The term “precision,” in this context, refers to tests that are conducted to ev...
IEEE Standard Power Cable Ampacity Tables Amendment 1: Revision to Introduction
Corrections to the introduction for the standard with over 3000 ampacity tables for extruded dielectric power cables rated through 138 kV and laminar dielectric power cables rated through 500 kV are addressed in this amendment.