Browse Standards
IEEE Guide for Design of Direct Current Overhead Contact Systems for Transit Systems
The general parameters used in the design of direct current overhead contact systems used in transit systems are defined in this guide. The guidelines mentioned in this document are intended to be used for the design of either new or expand...
IEEE Guide for Conducting Corona Tests on Hardware for Overhead Transmission Lines and Substations
Uniform procedures for the testing of transmission line and station bus hardware in high voltage laboratories are established in this guide. Two tests are described: the first is a visual corona test, the second is a radio interference volt...
IEEE Guide for Electrical and Control Design of Hydroelectric Water Conveyance Facilities
Electrical and control design of water conveyance facilities associated with hydroelectric projects including associated penstocks, valves, and gates are described in this guide. Guidance to plan and prepare designs is included. Installatio...
IEEE Standard for Power Electronics Open System Interfaces in Zonal Electrical Distribution Systems Rated Above 100 kW - Redline
Open system interfaces for high power electronics equipment used in zonal electrical distribution systems rated above 100 kW are identified in this standard. The required power, monitoring, information exchange, control, and protection inte...
IEEE Standard for Universal Power Adapter for Mobile Devices
A power delivery connection between a power adapter and a power using device greater than 10 W and up to, but less than 240 W, is defined in this standard. A communications link between the power adapter and the mobile power-using device is...
IEEE Guide on the Selection of Transmission and Distribution Insulators with Respect to Cold Weather Conditions
Procedures for selecting external insulation that is likely to be subjected to an outdoor environment that includes combinations of contamination, ice, snow, or cold fog are specified by this guide. The selection methods are applicable to i...
IEEE Standard for Risk-Informed Categorization and Treatment of Electrical and Electronic Equipment at Nuclear Power Generating Stations and Other Nuclear Facilities
This standard addresses the following: Risk-informed methods have been established to appropriately categorize components as either safety significant or low safety significant. Application of these methods has been shown to be safety-benef...
IEEE Approved Draft Guide for Preparation Techniques of Shielded Cables Rated 2.5 kV through 46 kV and the Installation of Mating Accessories
Accepted best industry practices for the preparation of shielded medium voltage cables rated 2.5 kV through 46 kV for the installation of mating accessories are defined in this guide. The information is intended to supplement cable accessor...
IEEE Standard for Exchanging Information Between Networks Implementing IEC 61850 and IEEE Std 1815(TM) [Distributed Network Protocol (DNP3)]
This document specifies the standard approach for mapping between IEEE Std 1815™ [Distributed Network Protocol (DNP3)] and IEC 61850 (Communications Networks and Systems for Power Utility Automation). Two primary use cases are addressed: a...
IEEE Standard for Electric Power Systems Communications-Distributed Network Protocol (DNP3) - Redline
The DNP3 protocol structure, functions, and interoperable application options (subset levels) are specified. The simplest application level is intended for low-cost distribution feeder devices, and the most complex for full-featured systems...