Browse Standards
IEEE Standard Quality Assurance Program Requirements for the Design and Manufacture of Class 1E Instrumentation and Electric Equipment for Nuclear Power Generating Stations
This standard establishes the basic Quality Assurance Program requirements to be implemented by manufacturers of Class 1E Instrumentation and Electric Equipment for Nuclear Power Generating Stations.
IEEE Standard Test Specifications for Gas Tube Surge Protecting Devices
This standard applies to surge-protective devices for application on systems with voltages equal to or less than 600 V rms. These protective devices are designed to limit voltage surges on balanced or unbalanced communication circuits and d...
IEEE Standard for Electrical Measuring Transducer for Converting AC Electrical Quantities into DC Electrical Quantities
This standard applies to measuring transducers used for converting AC electrical quantities such as current, voltage, power (active or reactive), power factor, phase angle or frequency to direct current or voltage. Within the effective rang...
IEEE Recommended Practice for the Detection and Measurement of Partial Discharges (Corona) During Dielectric Tests
This document is based on IEC Publication 270-1968, Partial Discharge Measurements. adheres closely to the IEC recommendations with the following exceptions:(1) The terms partial discharge energy and partial discharge power are not used in ...
IEEE Recommended Practice for Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for Stationary Applications - Redline
Maintenance, test schedules, and testing procedures that can be used to optimize the life and performance of permanently installed, vented lead-acid storage batteries used for standby service are provided. Guidance to determine when batteri...
IEEE Guide for Making Corona (Partial Discharge) Measurements on Electronics Transformers
A uniform procedure for making corona (partial discharge) measurements by electrical means on electronic transformers is presented. Methods of applying voltage stress, the use of a sine-wave voltage to simulated dc and ac combinations, the ...
IEEE Guide for Functional Evaluation of Insulation Systems for AC Electric Machines Rated 2300 V and Above
A procedure that may be used to evaluate and compare insulation systems used, or proposed for use, in large ac electric machines is described in this guide.
IEEE Guide for Insulation Maintenance for Rotating Electric Machinery (5 Hp to Less Than 10 000 Hp)
In this standard, information necessary to permit an effective evaluation of the insulation systems of medium and small rotating electric machines is presented. The guide is intended to apply in general to industrial air-cooled machines rat...
AIEE Proposed Standard for Presenting Data on Magnetic Core Materials
The scope of this standard is to set forth the basic data on magnetic amplifier core materials that should be presented by manufacturers of core materials so that the magnetic amplifier designer will have available the parameters of the mat...
IEEE Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations
Uniform procedures for the measurement of radio noise generated by corona from overhead power lines and substations are established in this standard. Measurement procedures in this standard are also valid for other power-line noise sources ...