Browse Standards
IEEE Standard for Testing and Performance of Optical Ground Wire (OPGW) for use on Electric Utility Power Lines - Redline
The performance, test requirements, procedures, and acceptance criteria for a transmission line overhead ground wire (a.k.a. shield wire, static wire, earth wire, skywire) with optical fibers commonly known as optical ground wire (OPGW) are...
IEEE Recommended Practice for the Implementation of Inductive Coordination Mitigation Techniques and Application
Guidance for controlling or modifying the inductive environment and the susceptibility of affected wire line telecommunications facilities in order to operate within the acceptable levels of steady-state or surge induced voltages of the env...
IEEE Guide for Moisture Measurement and Control in SF6 Gas-Insulated Equipment - Redline
Guidelines for moisture level measurement, moisture data interpretation, and moisture control in gas-insulated switchgear (GIS) are provided.
IEEE Standard for Digital Recorders for Measurements in High-Voltage and High-Current Impulse Tests
The terms specifically related to the digital recorders used for making high-voltage and high-current impulse measurements are defined in this standard, which also specifies the necessary performance characteristics for such digital recorde...
IEEE Standard for Microcontroller System Serial Control Bus
A serial control bus for interdevicehtrabuilding as well as intrasite interconnection of microcontrollers is described. The bus, which is defined for (but not limited to) microcontrollers and devices with limited reprogrammability, provides...
IEEE Guide for Synchronous Generator Modeling Practices and Parameter Verification with Applications in Power System Stability Analyses - Redline
Categorized in this guide are three direct-axis and four quadrature-axis models, along with the basic transient reactance model. Also discussed are some of the assumptions made in using various models. The fundamental equations and concepts...
IEEE Recommended Practice for Thermal Evaluation of Sealed Insulation Systems for AC Electric Machinery Employing Random-Wound Stator Coils
A test procedure for comparing expected life, at rated temperature, of two or more sealed insulation systems is outlined. The procedure is limited to insulation systems for ac electric machines using random-wound stator coils. It is the int...
IEEE Recommended Practice for Installation, Maintenance, Testing, and Replacement of Vented Nickel-Cadmium Batteries for Stationary Applications - Redline
This recommended practice provides recommendations for installation design and for installation, maintenance, and testing procedures that can be used to optimize the life and performance of vented nickel-cadmium batteries, including partial...
IEEE Standard for Mechanical Rear Plug-in Units Specifications for Microcomputers Using IEEE 1101.1 and IEEE 1101.10 Equipment Practice
Additional dimensions that will ensure mechanical interchangeability of subracks and plug-in units based on IEEE P1101.1 (D1.0, 1997), IEEE Std 1101.10-1996, and the environmental requirements of IEC 61587-1 (May 1998-Draft) and IEC 61587-3...
IEEE Standard for Additional Mechanical Specifications for Microcomputers Using the IEEE 1101.1-1998 Equipment Practice
A generic standard that may be applied in all fields of electronics where equipment and installations are required to conform to the 482.6 mm (19 in) equipment practice based on IEEE Std 1101.1-1991, IEC 297-3 (1984), and IEC 297-4 (1995). ...