Browse Standards
IEEE Standard for Electrical Installation of Packaging Machinery and Associated Equipment
This standard covers the application of electrical equipment and wiring furnished as part of a packaging machine and associated equipment commencing at the place of connection of the power supply. It shall apply to electrical equipment for ...
IEEE Application Guide for Transient Recovery Voltage for AC High-Voltage Circuit Breakers rated on a symetical current basis.
This standard covers the application guide for transient recovery voltage requirements for ac high-voltage circuit breakers rated above 1000 volts and on a symmetrical current basis. The capability limits of these circuit breaker interrupti...
IEC/IEEE International Standard - Nuclear facilities -- Electrical equipment important to safety -- Qualification - Redline
IEEE Recommended Practice: Rules for the Use of Units of the International System of Units
IEEE Application Guide for High Voltage Circuit Breakers Rated on a symmetrical current Basis
This application guide applies to AC high-voltage circuit breakers rated in accordance with the methods given in American National Standard Rating Structure for AC High-Voltage Circuit Breakers, C37.04-1964 (R 1969) and listed in American N...
IEEE Trial Use Standard Guide on Solid State Devices: Varactor Measurements Part 1- Small Signal Measurements
This guide describes several methods of measurement for the small signal characterization of varactors. For the purpose of this guide, a varactor is defined as a twoterminal device used as a voltage-dependent capacitance. Such devices can b...
IEEE Draft Standard for Electric Penetration Assemblies in Containment Structures for Nuclear Power Generating Stations
An electric penetration assembly is an assembly of insulated electric conductors, conductor seals, module seals (if any), and aperture seals that provides the passage of the electric conductors through a single aperture in the nuclear conta...
IEEE Draft Standard Requirements for Direct Current Instrument Shunts
The dc instrument shunts within this standard apply to shunts for use in direct current circuits to extend the current measuring range of devices (e.g. instruments, meters, protective relays, or low-voltage trip systems). The design and tes...
IEEE Standard American National Standard Canadian Standard Graphic Symbols for Electrical and Electronics Diagrams (Including Reference Designation Letters)
IEEE Standards Report on State of the Art of Measuring. Unbalance Transmission-Line Impedance
This document is concerned with reporting the state of the art of measuring impedance in distributed parameter coaxial waveguide systems, propagating a TEM wave. Coaxial lines can be used from direct current to above 40 gigahertz, but are w...