Browse Standards
IEEE Standard for Qualification of Safety-Related Actuators for Nuclear Power Generating Stations and Other Nuclear Facilities - Redline
Direction for the implementation of the requirements of IEC/IEEE 60780-323 as they apply to the specific features of safety-related actuator qualification are provided. This standard establishes criteria for qualification of safety-related ...
IEEE Definitions of Terms Used in IEEE Standards on Nuclear Power Generating Stations
All of the terms and definitions in this document have been taken from current IEEE standards on nuclear power generating stations. The source of each definition is indicated by a number in brackets immediately following the definition in S...
IEEE Guide for Application of the Single-Failure Criterion to Nuclear Power Generating Station Safety Systems
Guidance for the application of the single-failure criterion to the electrical power, instrumentation, and control portions of nuclear power generating safety systems are provided in this guide.
IEEE Standard for Application of the Single-Failure Criterion to Nuclear Power Generating Station Safety Systems
Requirements for the application of the single-failure criterion to the electrical power, instrumentation, and control portions of nuclear power generating safety systems are provided in this standard.
IEEE Standard on Network Analyzers (100 kHz to 18GHz)
This standard was written for users and manufacturers of automatic network analyzers. The purpose of the standard is to provide common terminology, to give performance parameters required for describing and specifying network analyzers, and...
IEEE Standard for Electrical Characterization of Printed Circuit Board and Related Interconnects at Frequencies up to 50 GHz
Standard and recommended practices for ensuring the quality of measured data for high-frequency electrical interconnect at frequencies up to 50 GHz are provided. This might include, but is not limited to recommending design of test fixtures...
IEEE Recommended Practice for Determining the Electric Power Station Ground Potential Rise and Induced Voltage from a Power Fault - Redline
Guidance for the calculation of power station ground potential rise (GPR) and longitudinal induction (LI) voltages is provided, as well as guidance for their appropriate reduction from worst-case values, for use in metallic telecommunicatio...
IEEE Guide for Protective Relaying of Utility-Consumer Interconnections
The physical means by which electric energy is received from the electric utility is known as an electric interconnection. The primary elements include transmission or distribution circuits, transformers, and switching devices in the form o...
IEEE Guide for General Principles of Reliability Analysis of Nuclear Power Generating Station Systems and Other Nuclear Facilities - Redline
General reliability and availability analysis methods that can be applied to structures, systems, and components (SSCs) in nuclear power generating stations and other nuclear facilities are contained in this guide.
IEEE Trial Use Standard Guide on Solid State Devices: Varactor Measurements Part II - Characterization of Large-Signal Devices
This standard describes parameters and methods of measurement suitable for the characterization of varactors intended for large-signal application. This will be done by reference to the parameters and methods prescribed in IEEE Std 318-1971...