Browse Standards
IEEE Test Procedure for Evaluation of Insulation Systems for Electronics Power Transformers
The intent of this Test Procedure is to establish a uniform method by which the life of electronics transformer insulation systems can be compared. Thermal degradation is generally one of the major factors affecting the life of most insulat...
IEEE Standard for High-Power Wide-Band Transformers (100 Watts and Above)
This publication pertains to wide-band transformers, transmitting power of equal to or more than 100 W. Guides to application and test procedures are included. Appendices contain certain precautions and recommended practices. Provision is m...
IEEE Standard for Measurement of Radio Noise Generated by Motor Vehicles and Affecting Mobile Communications Receivers in the Frequency Range 25-1000 megahertz
IEEE Trial Use Standard Dielectric Test Requirements for Power Transformers for Operation on Effectively Grounded Systems 345 kV and Above
This standard prescribes insulation levels and dielectric test requirements for power transformers where: (1) The transformer insulation levels and dielectric test requirements are specified to be in accordance with this standard. (2) The h...
American National Standard Test Code for Distribution, Power, and Regulating Transformers
This standard prescribes methods for performing tests specified in American National Standard General Requirements for Distribution, Power, and Regulating Transformers, C57.12.00-1973 (IEEE Std 462-1973) and in the separate transformer stan...
IEEE Letter Symbols for Thermoelectric Devices
This document presents standard letter symbols for quantities used in the field of thermoelectric devices.
IEEE Standard for Letter Symbols for Measurement Units (SI and Other Common Units)
Letter symbols and corresponding units for SI and other common measurement units are covered in this standard.
IEEE Standard Test Procedure for Evaluation of Systems of Insulation for Dry-Type Specialty and General-Purpose Transformers
A uniform method by which the thermal endurance of electrical insulation systems for dry-type specialty and general-purpose transformers can be compared is established. Covered are insulation systems intended for use in the types of transfo...
IEEE Technical Committee Report on Recommended Practices for Burst Measurements in the Time Domain
The evolution of technology and the advancement of communications have resulted in an increased awareness of energy bursts. Such bursts which interfere with desired signals are properly classified as noise. In the transmission of informatio...
IEEE Test Procedure for Semiconductor Diodes
This Standard recommends and describes methods of measurement of the important electrical characteristics of semiconductor diodes, For the purpose of this Standard, a semiconductor diode is defined as: "A semiconductor device having two ter...