Browse Standards
IEEE Standard for Microcontroller System Serial Control Bus
A serial control bus for interdevicehtrabuilding as well as intrasite interconnection of microcontrollers is described. The bus, which is defined for (but not limited to) microcontrollers and devices with limited reprogrammability, provides...
IEEE Draft Recommended Practice for Sizing Nickel-Cadmium Batteries for Stationary Applications
The sizing of nickel-cadmium batteries used in standby operation for stationary applications is discussed in this recommended practice.
IEEE Guide for Synchronous Generator Modeling Practices and Parameter Verification with Applications in Power System Stability Analyses - Redline
Categorized in this guide are three direct-axis and four quadrature-axis models, along with the basic transient reactance model. Also discussed are some of the assumptions made in using various models. The fundamental equations and concepts...
IEEE Guide for the Interconnection of User-Owned Substations to Electric Utilities
IEEE Std 1109-1990, IEEE Guide for the Interconnection of User-Owned Substations to ElectricUtilities, provides a checklist and selected guidance, for persons not normally practicing in this specialized field, of major technical design area...
IEEE Recommended Practice for Thermal Evaluation of Sealed Insulation Systems for AC Electric Machinery Employing Random-Wound Stator Coils
A test procedure for comparing expected life, at rated temperature, of two or more sealed insulation systems is outlined. The procedure is limited to insulation systems for ac electric machines using random-wound stator coils. It is the int...
IEEE Recommended Practice for Installation, Maintenance, Testing, and Replacement of Vented Nickel-Cadmium Batteries for Stationary Applications - Redline
This recommended practice provides recommendations for installation design and for installation, maintenance, and testing procedures that can be used to optimize the life and performance of vented nickel-cadmium batteries, including partial...
IEEE Standard for Mechanical Rear Plug-in Units Specifications for Microcomputers Using IEEE 1101.1 and IEEE 1101.10 Equipment Practice
Additional dimensions that will ensure mechanical interchangeability of subracks and plug-in units based on IEEE P1101.1 (D1.0, 1997), IEEE Std 1101.10-1996, and the environmental requirements of IEC 61587-1 (May 1998-Draft) and IEC 61587-3...
IEEE Standard for Additional Mechanical Specifications for Microcomputers Using the IEEE 1101.1-1998 Equipment Practice
A generic standard that may be applied in all fields of electronics where equipment and installations are required to conform to the 482.6 mm (19 in) equipment practice based on IEEE Std 1101.1-1991, IEC 297-3 (1984), and IEC 297-4 (1995). ...
IEEE Standard for Space Applications Module, Extended Height Format E Form Factor
Withdrawn Standard. Withdrawn Date: Jan 15, 2001. The design requirements for a module designated for use in spacecraft, boosters, and other highly rugged, conductively cooled environments are established in this standard. The requirements ...
IEEE Standard for Military Module, Format E Form Factor
Withdrawn Standard. Withdrawn Date: Jan 15, 2001. No longer endorsed by the IEEE. The mechanical design requirements for a military module, format E form factor are established. The specificaitons of dimensions and tolerances are intended t...