Browse Standards
IEEE Standard Quality Assurance Program Requirements for the Design and Manufacture of Class 1E Instrumentation and Electric Equipment for Nuclear Power Generating Stations
This standard establishes the basic Quality Assurance Program requirements to be implemented by manufacturers of Class 1E Instrumentation and Electric Equipment for Nuclear Power Generating Stations.
IEEE Standard Test Specifications for Gas Tube Surge Protecting Devices
This standard applies to surge-protective devices for application on systems with voltages equal to or less than 600 V rms. These protective devices are designed to limit voltage surges on balanced or unbalanced communication circuits and d...
IEEE Standard for Electrical Safety Practices in Electrolytic Cell Line Working Zones - Redline
Means for improved safeguarding of personnel while operating or maintaining equipment located in electrolytic cell line working zones are provided in this standard. Related requirements for equipment and electrical conductor installations a...
IEEE Standard Definitions of Terms for Nonlinear, Active, and Nonreciprocal Waveguide Components
This standard presents definitions of terms for non-linear, active, and non-reciprocal waveguide components. It is a companion to two other published standards, Definitions of Fundamental Waveguide Terms, IEEE Std 146-1980 and Definitions o...
IEEE Recommended Practice for the Detection and Measurement of Partial Discharges (Corona) During Dielectric Tests
This document is based on IEC Publication 270-1968, Partial Discharge Measurements. adheres closely to the IEC recommendations with the following exceptions:(1) The terms partial discharge energy and partial discharge power are not used in ...
AIEE Proposed Recommended Guide for Specification of Signal Sources
The purpose of these specifications is to give a common basis for comparison among signal sources used for test purposes. It is recommended that all manufacturers supply the information outlined where applicable. It is recognized that furth...
IEEE Recommended Practice for Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for Stationary Applications - Redline
Maintenance, test schedules, and testing procedures that can be used to optimize the life and performance of permanently installed, vented lead-acid storage batteries used for standby service are provided. Guidance to determine when batteri...
IEEE Standard for Ferroresonant Voltage Regulators
Ferroresonant transformers used as regulators in electronic power supplies and in other equipment are covered. Guides to application and test procedures are included.
IEEE Recommended Practice for Emergency and Standby Power Systems for Industrial and Commercial Applications
This Recommended Practice addresses the uses, power sources, design, and maintenance of emergency and standby power systems. Chapter 3 is a general discussion of needs for and the configuration of emergency and standby systems. Chapter 9 li...
IEEE Standard Practices and Requirements for Thyristor Converters for Motor Drives Part 1- Converters for DC Motor Armature Supplies
This standard applies to all types of line-commutated semiconductor power converters employing monocrystalline semiconductor thyristors or diodes, as used in industrial motor-drive applications requiring adjustable direct voltage for dc mot...